The safe use method of industrial dust removal equipment

The safe use method of industrial Dust Removal Equipment

1. different types and sizes of vacuum cleaners have different structural and functional characteristics. Therefore, we must carefully read the instruction manual before choosing the vacuum cleaner to avoid damaging the vacuum cleaner and endangering personal safety.

2. the industrial vacuum cleaner should be at an altitude of no more than 1000 meters, well ventilated, the ambient temperature is not more than 40℃, no flammable, corrosive gas in the air, or in a similar environment.

3. before use, the hose should be connected with the suction mouth of the shell first, the hose and each section of the super long nozzle and the nozzle end of the nozzle, such as furniture brush, gap suction mouth, floor brush and so on to tighten. Because the inlet of the slot suction nozzle is less, the noise is high when used, and the continuous use time should not be too long.

4. connecting the ground line to ensure the safety of electricity. The continuous use time of the household vacuum cleaner does not exceed 1 hours. The continuous use time of the industrial vacuum cleaner does not exceed 8 hours to prevent the motor from overheating and burning.

5. when the vacuum cleaner is used, the power line is pulled out of enough length. Do not pull the power line over. If there is a yellow or red mark on the power line, stop pulling out. When you need to roll back the power cord, you can automatically retract it by pressing the button.

6. be careful not to touch the vacuum cleaner, and wet hands can't operate the machine. If there are large pieces of paper, paper, plastic cloth or something larger than the diameter of the straw, it should be excluded in advance, otherwise it will cause blockage in the suction pipe.

7. when the industrial vacuum cleaner is used for liquid absorption, the filter element should be removed to prolong its service life.

8. when used, depending on the occasion of cleaning, the suction control device can be properly adjusted. There is a circular hole on the elbow with a adjusting ring on which the suction is maximum when the adjusting ring covers the hole on the elbow, and the suction is minimized when the adjusting ring exposes all the holes. Some vacuum cleaners regulate the suction by means of motor speed regulation.

9. when the dust is found in the dusts, the dust should be removed and the dust on the filter should be eliminated. The good ventilation duct should be maintained to avoid the blocking filter and the suction force, the motor heating and the service life of the vacuum cleaner.

10. when the vacuum cleaner is used for a period of time, the dust will gather on the filter belt. At this time, the ash rack on the vacuum cleaner can be shaken to restore the suction. If the shaking frame is not shaken, the suction can not be resumed, indicating that the dust in the bucket is full and should be removed in time.

11. the vacuum cleaner motor is mostly a high-speed motor. After long run, the brush is easy to wear. The domestic vacuum cleaner should be replaced once a year to a year and a half.

12. when the vacuum cleaner is used, it should be kept in dry place. If it is placed in an excessive humidity area, it will affect the electrical insulation and service life.